Correcting a mis-pick

If you pick an item by mistake — or a scanner fires twice — you can un-pick it at any time using the **[−]** button on the action bar. ## The pick tri-control The action bar shows **[−] count/total Picked [+]** throughout the pick flow: * Tap **[+]** to pick one unit (or confirm a scan) * Tap **[−]** to un-pick one unit — even if the item was already marked as done * Long-press either end to open a quantity entry field for bulk corrections In Pick list mode, each row has its own **[−] [+]** counter so you can correct any item independently. ## Correcting in Required scan mode When scan verification is set to Required, the **[+]** button is disabled — you must scan the item to add it. However, **[−]** is always active, so you can always correct an over-pick without needing a manager's intervention. ## Bulk corrections Long-press either end of the **[−] [+]** control to open a quantity entry field. Type the correct count and confirm — the pick total updates immediately.